NEWS from PENNSYLVANIA DEPARTMENT OF TRANSPORTATION

Culvert Replacement project to begin on Butternut Flats Road (Route 1007)

Posted 8/7/26

DUNMORE, PA — PennDOT will be closing Butternut Flats Road (Route 1007) in Honesdale starting Monday, August 10, 2026, through the end of summer 2026 for a culvert replacement project. The detour …

This item is available in full to subscribers.

Please log in to continue

Log in
NEWS from PENNSYLVANIA DEPARTMENT OF TRANSPORTATION

Culvert Replacement project to begin on Butternut Flats Road (Route 1007)

Posted

DUNMORE, PA — PennDOT will be closing Butternut Flats Road (Route 1007) in Honesdale starting Monday, August 10, 2026, through the end of summer 2026 for a culvert replacement project. The detour can be found below:

From Route 1007 from the west

  • Turn left onto Route 1005
  • Turn right onto Route 1002
  • Turn right onto Eighmy Road
  • Turn left onto Route 1007

From Route 2023 from the east

  • Turn right onto Eighmy Road
  • Turn left onto Route 1002
  • Turn left onto Route 1005
  • Turn right onto Fox Hill Road (Route 1007)

When encountering a work zone, please drive the posted speed limit, turn on your headlights, pay close attention to signs and flaggers, and avoid all distractions. In high-traffic locations, motorists are encouraged to use both lanes of travel to the merge point.

Travelers can check conditions on major roads by visiting www.511PA.com. 511PA, which is free and available 24 hours a day, provides traffic delay warnings, weather forecasts, traffic speed information, and access to more than 1,200 traffic cameras. 511PA is also available through a smartphone application for iPhone and Android devices, by calling 5-1-1, or by following regional X alerts.

Find PennDOT’s planned and active construction projects at www.penndot.pa.gov/D4Results Subscribe to PennDOT news and traffic alerts in Lackawanna, Luzerne, Pike, Susquehanna, Wayne, and Wyoming counties at http://www.penndot.gov/District4

Butternut Flats Road, Route 1007

Comments

No comments on this item Please log in to comment by clicking here